Coating - Protective treatment

Select suitable products to match the surface to be protected (type / square metres).

Put up the warning sign.

Completely remove stubborn dirt, care products and protective treatments with the suitable cleaning method as needed (e.g. wet scrubbing and wet vacuuming).

As needed: Fill the pores

Allow the floor covering to dry completely.

Remove any loose dirt (dust-binding mopping or dry vacuum cleaning).

Pour a little bit of undiluted coating agent onto the floor and use the application tool with cover to apply it in a thin and even layer, moving in slightly overlapping passes (circular motion). Leave to soak, distribute any excess coating agent. Work backwards towards the exit.

To apply additional passes, pour a little coating agent onto the wet area and spread it as described above. Repeat this step until the entire area has been treated.

Always lift up the application tool from the floor like "an airplane taking off”.

Allow the floor covering to dry completely.

Intermediate sanding as needed: Dry sand the floor covering using the single-brush machine and the scrubbing pad. Remove any loose dirt.

As needed: Apply a second and possibly a third layer of coating agent.

Allow the floor covering to dry completely.

Perform a visual check.

Remove the warning sign once the coating is dry.

Rinse the cover and wash it in the washing machine.

Dispose of any waste.

Clean the cleaning equipment and replace as needed